Study Of The Surface Integrity Of The Machined Workpiece In The EDM Of SKD 11 Tool Steel.
ACKNOWLEDGEMENT
It is my greatest experience to have an o pportunity to complete this project of
"Study of the surface integrity of the machined workpiece in the EDM of SKD 11 tool
steel''
rn completion of the dissertation, the author has obtained tremendous help and
guidance from many parties. This segment is especially dedicated to a ll that had been
such a remarkable help directly and indirectly till the end of this project. Without their
support this project wil l never meet its completion.
The authors deepest gratitude and thank goes to Un iversiti Tek.nikal Ma laysia
Melaka (UTeM) for supporting work under the Un iversity Short Term Research G rant
No.PJP/2008/FKP(3)-S42 1. The greatest thank also goes to Ybhg. Or. Mohd Rizal
Bin Salleh, Dean of Faculty of Manufacturing Engineering for his support and
encourage in doing th is project. T he thanks also dedicated to Centre for Research and
Innovation Management (CRIM). Universiti Tekn ikal Malaysia Me laka (UTeM) for
their guidance towards the project completion.
The authors also wish to extend sincere appreciation to Prof.Dr.Mohd Razali bin
Muhamad and all those who have assisted directly and indirectly towards the
completion of this project. Hopefully, thi s project will be a success and inspire future
technology and knowledge.
iii
© Universiti Teknikal Malaysia Melalal
It is my greatest experience to have an o pportunity to complete this project of
"Study of the surface integrity of the machined workpiece in the EDM of SKD 11 tool
steel''
rn completion of the dissertation, the author has obtained tremendous help and
guidance from many parties. This segment is especially dedicated to a ll that had been
such a remarkable help directly and indirectly till the end of this project. Without their
support this project wil l never meet its completion.
The authors deepest gratitude and thank goes to Un iversiti Tek.nikal Ma laysia
Melaka (UTeM) for supporting work under the Un iversity Short Term Research G rant
No.PJP/2008/FKP(3)-S42 1. The greatest thank also goes to Ybhg. Or. Mohd Rizal
Bin Salleh, Dean of Faculty of Manufacturing Engineering for his support and
encourage in doing th is project. T he thanks also dedicated to Centre for Research and
Innovation Management (CRIM). Universiti Tekn ikal Malaysia Me laka (UTeM) for
their guidance towards the project completion.
The authors also wish to extend sincere appreciation to Prof.Dr.Mohd Razali bin
Muhamad and all those who have assisted directly and indirectly towards the
completion of this project. Hopefully, thi s project will be a success and inspire future
technology and knowledge.
iii
© Universiti Teknikal Malaysia Melalal