1. Home
  2. Lainnya

PREDICTION SURFACE ROUGHNESS IN HIGH-SPEED MILLING OF INCONEL 718 UNDER MQL USING RSM METHOD.

Dokumen yang terkait

Simulation Of Cutting Force During High Speed End Milling Of Inconel 718.

0 2 24

Investigation The Effectiveness Of EDM Performance And Tool Roughness On Surface Finish Of Inconel 718.

0 2 24

Effect Of Cutting Parameter On Roughness During Surface Grinding Of Inconel 718.

0 2 24

Study On Wear Rate Of TiAIN Ball Nose During Milling Inconel 718 Under Flooded Lubrication.

0 2 24

The influence of cutting parameter on heat generation in high-speed milling Inconel 718 under MQL condition.

0 3 4

Multi-objective optimization using Box-Behnken of response surface methodology for high-speed machining of Inconel 718.

0 4 7

Prediction of cutting force in end milling of Inconel 718.

0 3 8

Comparison between up-milling and down-milling operations on tool wear in milling Inconel 718.

0 2 7

Tool Life of TiAlN PVD Coated Carbide Tool in High-speed End Milling of Untreated Inconel 718 under Minimum Quantity Lubrication Condition.

0 3 6

Surface roughness optimization in an end-milling operation using the Taguchi design method

0 1 7