DESIGN OF TEMPERATURE CONTROL SYSTEM ON THE CHICKEN’S EGG INCUBATOR.

DESIGN OF TEMPERATURE CONTROL SYSTEM ON THE
CHICKEN’S EGG INCUBATOR
ByEndah Lis Setiarini
09306144028
ABSTRACT
This research aims to design and make temperature control for the chicken’s
egg incubator in accordance with the desired set point and to analyze the
temperature control system in the chicken’s egg incubator using an ON-OFF
control system circuit.
The temperature control system in the chicken’s egg incubator was
controlled by a circuit of temperature transducer using two inputs into a
differential amplifier (IC LM 358). These ware the output of the voltage divider as
voltage reference ( )and a feedback signal from the temperature sensor LM
35DZ as input voltage ( ! ). The two inputs of the differential amplifier caused
the amplifier to respond the two inputs by processing comparison and resulting in
an error signal. If LM 358 output with positive polarity (+) was greater than 0,77
V, switching transistor would reach saturation. The saturation caused the switch to
be activated so that the four light bulbs would be ON and produced heat. This
went the other way around. This equipment was able to control the temperature
required in order to hatch eggs properly which was from (38.5 to 40.5) ° C.
The capacity of this equipment was 20 eggs and this had been tested

properly to incubate eggs. During the first trial 12 eggs were hatched among 16
eggs. This means that the success rate of the first trial was 75 %. For the second
trial there were 12 eggs among 14 eggs were hatched, so that the success rate was
85,71 %.

Keywords : control system, temperature, egg incubator, ON-OFF action

viii

RANCANG BANGUN SISTEM KONTROL SUHU PADA ALAT PENETAS
TELUR AYAM
Oleh :
Endah Lis Setiarini
09306144028
ABSTRAK
Penelitian ini bertujuan untuk merancang dan membuat

kontrol suhu

untuk alat penetasan telur ayam sesuai dengan set point yang diinginkan dan

menganalisis sistem kontrol suhu pada penetasan telur ayam dengan
menggunakan rangkaian sistem kontrol aksi ON-OFF.
Suhu di dalam ruang inkubator dikontrol menggunakan rangkaian
tranduser suhu dengan menggunakan dua masukan pada penguat selisih(IC LM
358) yaitu output dari pembagi tegangan sebagai tegangan referensi ( ) dan
sinyal feedback dari sensor suhu LM 35DZ sebagai tegangan input ( ! ).Dengan
adanya dua masukan pada penguat selisih, maka penguat akan merespon dua
masukan tersebut dan melakukan proses pembandingan dengan hasil berupa
sinyal error.Selanjutnya output LM 358 dengan polaritas positif (+) lebih dari
0,77 V akan membuat transistor yang difungsikan sebagai switching mencapai
titik saturasi/ON. Akibat dari saturasi tersebut relay yang difungsikan sebagai
saklar akan aktif sehingga arus yang mengalir ke elemen pemanas (lampu pijar)
akan menghasilkan panas, dan begitu sebaliknya. Alat ini mampu mengendalikan
suhu yang diperlukan telur ayam agar dapat menetas dengan baik yaitu sekitar
(38,5-40,5)°C. Pemanas ruang inkubator berupa 4 buah lampu dengan
dayamasing-masing 5 W.
Alat ini memiliki kapasitas 20 butir telur yang telah diuji coba untuk
menetaskan telur dengan baik. Tahap pertama jumlah telur yang ditetaskan
sebanyak 16 butir; jumlah telur yang menetas sebanyak 12 butir dan 4 butir tidak
menetas; tingkat keberhasilan penetasan telur pertama adalah 75%.Untuk tahap

kedua jumlah awal telur sebanyak 14 butir; menetas sebanyak 12 butir dan tidak
menetas sebanyak 2 butir;tingkat keberhasilan penetasan telur kedua adalah
85,71%.
Kata kunci : sistem kontrol, suhu, penetas telur,aksi ON-OFF
vii