Kisi-Kisi Soal LKS Untuk Menyambut LKS SMK 2017 - Silabus Task A-EFI
AUTOMOBILE TECHNOLOGY
Competitor Name
Competitor No
Task
A
ETU ELECTRONIC FUEL INJECTION
Familiarization Time
5 minutes
Task Duration
55 minutes
Total Time
60 minutes
Section
Possible Mark
1.
Preparation ( PPE Used, Safety and Health Environment)
150
2.
300
4.
Repair engine to start and run
Diagnosis Engine Control System use Scan Tool or jumper
cable
Checks and measure EFI Components
5.
Use of the exhaust gas analyser
150
3.
Task Total
200
200
1000
You are required to
- Observe occupational health & safety standard
- Only ask necessary questions
- Not speak to the public while competing
- Comply with Experts instructions
- Ensure Competitor Number on all forms
- Use appropriate tools and procedure
- Complete all instructions on the next page
Remark: Vehicle/model : Daihatsu Great New Xenia 1.3 1NR-VE 2015
1
LKS Nasional 2017
ATTENTION
1.
This Vehicle ( Daihatsu Great New Xenia 1NR-VE 2015 ) on problem condition
(Engine can not run).Found this problem and repair so engine can to run.
2.
After engine can to run , found problem on Engine Control System by scan tool
and read engine check lamp blinking.
3.
You may use tools and equipment you have, and is provide for you to diagnose
and repair problems found.
4.
Show to the judge what you have found and ask to him for repair-parts
needed
5.
Repair problem on this vehicle appropriate on standard procedure.
6.
Check and measure sensors part on your desk properly.
7.
Check the exhaust emission using the Emission Analyzer and record your
findings.
2
LKS Nasional 2017
Report Sheet
No
1.
Performance
Components
Good
Bad
Items
Fuel Injector Inspection
Resistance Injector
2.
3.
________ Ohm
Throttle Motor Unit
Terminal 1 (M-) with 2 (M+)
________ Ohm
THA 1(THA) with 2(E2) at 20˚C
________ Ohm
Reading Current Data
4.
Intake Air Temperature
___________˚C
5.
Coolant Temperature
___________˚C
6.
Target Throttle Position
Pedal Accelerator Fully Closed ___________%
Pedal Accelerator Fully Open
___________%
Exhaust Emission Test
7.
8.
Idling Speed
CO reading
________________ %
CO2 reading
________________ %
Lamda reading
________________
HC reading
________________ ppm
At 2,500 rpm
CO reading
________________ %
CO2 reading
________________ %
Lamda reading
________________
HC reading
________________ ppm
3
LKS Nasional 2017
4
LKS Nasional 2017
Competitor Name
Competitor No
Task
A
ETU ELECTRONIC FUEL INJECTION
Familiarization Time
5 minutes
Task Duration
55 minutes
Total Time
60 minutes
Section
Possible Mark
1.
Preparation ( PPE Used, Safety and Health Environment)
150
2.
300
4.
Repair engine to start and run
Diagnosis Engine Control System use Scan Tool or jumper
cable
Checks and measure EFI Components
5.
Use of the exhaust gas analyser
150
3.
Task Total
200
200
1000
You are required to
- Observe occupational health & safety standard
- Only ask necessary questions
- Not speak to the public while competing
- Comply with Experts instructions
- Ensure Competitor Number on all forms
- Use appropriate tools and procedure
- Complete all instructions on the next page
Remark: Vehicle/model : Daihatsu Great New Xenia 1.3 1NR-VE 2015
1
LKS Nasional 2017
ATTENTION
1.
This Vehicle ( Daihatsu Great New Xenia 1NR-VE 2015 ) on problem condition
(Engine can not run).Found this problem and repair so engine can to run.
2.
After engine can to run , found problem on Engine Control System by scan tool
and read engine check lamp blinking.
3.
You may use tools and equipment you have, and is provide for you to diagnose
and repair problems found.
4.
Show to the judge what you have found and ask to him for repair-parts
needed
5.
Repair problem on this vehicle appropriate on standard procedure.
6.
Check and measure sensors part on your desk properly.
7.
Check the exhaust emission using the Emission Analyzer and record your
findings.
2
LKS Nasional 2017
Report Sheet
No
1.
Performance
Components
Good
Bad
Items
Fuel Injector Inspection
Resistance Injector
2.
3.
________ Ohm
Throttle Motor Unit
Terminal 1 (M-) with 2 (M+)
________ Ohm
THA 1(THA) with 2(E2) at 20˚C
________ Ohm
Reading Current Data
4.
Intake Air Temperature
___________˚C
5.
Coolant Temperature
___________˚C
6.
Target Throttle Position
Pedal Accelerator Fully Closed ___________%
Pedal Accelerator Fully Open
___________%
Exhaust Emission Test
7.
8.
Idling Speed
CO reading
________________ %
CO2 reading
________________ %
Lamda reading
________________
HC reading
________________ ppm
At 2,500 rpm
CO reading
________________ %
CO2 reading
________________ %
Lamda reading
________________
HC reading
________________ ppm
3
LKS Nasional 2017
4
LKS Nasional 2017