General: Set the following for use with the custom token in this chapter. Click Save and dismiss the confirmation window or click Cancel without

Writing Oracle Security Token Service Module Classes 4-19 c. Proceed to Section 4.5.4, Adding the Custom Token to the Relying Party Profile .

4.5.4 Adding the Custom Token to the Relying Party Profile

You can either edit an existing Relying Party profile, or create a new one to issue the custom token by default, and refer to the Issuance Template and related information. Either way, configure: ■ Default token to issue: email your custom token ■ Issuance Template: email-issuance-temp Prerequisites Your Custom Token and Issuance Template must be defined. To edit the requester profile for the custom module classes 1. From the Oracle Access Suite System Configuration tab, open the Security Token Services section. 2. In the navigation tree, open the Partner Profiles node and double-click the Relying Party Profiles node to display a list of existing profiles.

3. Existing Profile

: a. In the Search Results table of the Relying Party Profiles page, click the name of the desired profile. b. Click the Token and Attributes tab.

c. Token Type Configuration

: Click the Add + button above the Token Type Configuration table and enter the following details: Token type: email Issuance Template: email-issuance-temp

d. Attributes

: Click the Add + button above the Attributes table and define the following: Attribute name: mail Store Type: Userstore Include in Token: check to enable Encryption leave blank Value leave blank e. Click Apply, dismiss the confirmation window, and close the page or click Cancel to dismiss the page without submitting it.

4. New Profile

: Click the New Relying Party Profile button to display the New Partner Profile page where you enter details:

a. General

: Fill in the following details for the custom token in this chapter and then click the Next button at the top of the page. Profile ID: unique_relyingparty-name Default Token: email b. Click the Token and Attributes tab and perform Steps 2c and 2d, then click Apply.