3-8 Oracle Fusion Middleware Quick Installation Guide for Oracle Identity Management
■
Determining Port Numbers
■
Completing an Installation
■
Locating Installation Log Files
3.2.1 Starting an Installation
This topic explains the steps that are common to starting most Oracle Identity and Access Management installations and configurations. It begins with starting the
Installer and ends after you complete the steps on the Prerequisites Check screen.
Perform the following steps to start an Oracle Identity and Access Management installation:
1. Extract the contents of the ofm_iam_generic_11.1.1.5.0_disk1_1of1.zip
file to a directory.
2. Move to the Disk1 directory.
3. Start the Installer by executing one of the following commands:
UNIX : full path to the runInstaller directoryrunInstaller
-jreLoc Middleware Homejrockit_1.6.0_24jre
Windows : full path to the setup.exe directory\ setup.exe
-jreLoc Middleware Home\jrockit_1.6.0_24\jre
Notes:
■
If you are installing on an IBM AIX operating system, you must run the rootpre.sh script from the Disk1 directory before you
start the installer.
■
Starting the Installer as the root user is not supported.
Note:
The installer prompts you to enter the absolute path of the JDK that is installed on your system. When you install Oracle WebLogic
Server, the jrockit_1.6.0_24 directory is created under your Middleware Home. You must enter the absolute path of the JRE folder
located in this JDK when launching the installer. For example, on Windows, if the JRE is located in
D:\oracle\Middleware\jrockit_1.6.0_24, then launch the installer from the command prompt as follows:
D:\setup.exe -jreLoc D:\oracle\Middleware\jrockit_ 1.6.0_24\jre
If you do not specify the -jreLoc option on the command line when using the Oracle JRockit JDK, the following warning message is
displayed:
-XX:MaxPermSize=512m is not a valid VM option. Ignoring
This warning message does not affect the installation. You can continue with the installation.
Performing Common Installation Tasks 3-9
After the Installer starts, the Welcome screen appears. Continue by referring to the appropriate procedure in this document for the installation you want to perform.
3.2.2 Starting Oracle Fusion Middleware Configuration Wizard
