Module 2 - CADD_LKS2017

Competitor Station No. :_____________________

MECHANICAL ENGINEERING DESIGN - CAD
Module 2 – Day 3
Mechanical Fabrication – 4 hours

INSTRUCTIONS
1.
2.
3.

Do not open this question paper until you are told to do so.
Write your Station Number clearly at the top right-hand corner on the front
page of this question paper.
Return this question paper at the end of the test.

National Skills Olympic 2017_Mechanical Engineering Design-CAD (CADD)

: Mechanical Fabrication.
: 4 hours

Task
Time Allocation
I.

Introduction
A company is developing a ……………………………. You will model components of
as subassembly for the assembly.

II.

Description of Project and Tasks
Review the PDF and prints of the assemblies for ……………………………….. You
should also create a sheet metal parts, assemblies, and functional animations
of the assembly.

III.

Task
Create assemblies using parts you have created or found in the project folder.
1.

2.
3.
4.

IV.

Create
Create
Create
Create

“u
“u
“u
“u

-Asse
-Asse
-Asse
-Asse

ly
ly
ly
ly

ased o
ased o
ased o
ased o

pri
pri
pri
pri

ted do u e t i D ie
ted do u e t i D ie
ted document in 3D view)
ted do u e t i D ie

Create an Animation
a) Using Autodesk Inventor Studio, create a rendered image of the
complete assembly as follows:
1. Image size : 1024 x 768 pixels;
2. Select a Camera, Light style, and Scene style to best represent the
assembly.

b) Using Autodesk Inventor Studio, create an animation as follows:
1.
2.
3.
4.
5.
6.

V.

Screen size: 1024 x 768
Length : 20 seconds

From 0 to 8 seconds Motion 1
From 9 to 12 seconds Motion 2
From 13 to 15 seconds Motion 3
From 15 to 20 seconds Motion 4

Output
Save your drawing in folder My Documents: \MED-CAD-LKS SMK NASIONAL
2017\Module 2\Competitor Name\name of the component.

National Skills Olympic 2017_Mechanical Engineering Design-CAD (CADD)