Module 2 - CADD_LKS2017

Competitor Station No. :_____________________

MECHANICAL ENGINEERING DESIGN - CAD
Module 2 – Day 3
Mechanical Fabrication – 4 hours

INSTRUCTIONS
1.
2.
3.

Do not open this question paper until you are told to do so.
Write your Station Number clearly at the top right-hand corner
on the front page of this question paper.
Return this question paper at the end of the test.

National Skills Olympic 2017_Mechanical Engineering Design-CAD (CADD)

Task
: Mechanical Fabrication.
Time Allocation : 4 hours

I.

Introduction
A company is developing a ……………………………. You will
model components of as subassembly for the assembly.

II.

Description of Project and Tasks
Review the PDF and prints of the assemblies for
……………………………….. You should also create a sheet metal
parts, assemblies, and functional animations of the assembly.

III.

Task
Create assemblies using parts you have created or found in
the project folder.
1. Create
view)

2. Create
view)
3. Create
view)
4. Create
view)

IV.

“Sub-Assembly 1” (based on printed document in 3D
“Sub-Assembly 2” (based on printed document in 3D
“Sub-Assembly 3” (based on printed document in 3D
“Sub-Assembly 4” (based on printed document in 3D

Create an Animation
a) Using Autodesk Inventor Studio, create a rendered image
of the complete assembly as follows:
1. Image size : 1024 x 768 pixels;
2. Select a Camera, Light style, and Scene style to best
represent the assembly.

b) Using Autodesk Inventor Studio, create an animation as
follows:
1.
2.
3.
4.
5.
6.

V.

Screen size: 1024 x 768
Length : 20 seconds
From 0 to 8 seconds Motion 1
From 9 to 12 seconds Motion 2
From 13 to 15 seconds Motion 3
From 15 to 20 seconds Motion 4

Output

Save your drawing in folder My Documents: \MED-CAD-LKS SMK
NASIONAL
2017\Module
2\Competitor
Name\name
of
the
component.

National Skills Olympic 2017_Mechanical Engineering Design-CAD (CADD)