Kajian Dan Optimasi Kondisi Pemotongan Dengan Suhu Pemotongan Pada Pembubutan Baja AISI 4340 Menggunakan Pahat Karbida PVD Berlapis

xvi

DAFTAR PUSTAKA

[1]

Varaprasad.Bh, Srinivasa Rao.CH, P.V. Vinay., 2014, “Effect of
Machining Parameters on Tool Wear in Hard Turning of AISI D3 Steel”,
Global Congress on Manufacturing and Management, GCMM 2014

[2]

Suha K. Shihab, et al, “RSM Based Study of Cutting Temperature during
Hard Turning with Multilayer Coated Carbide Insert”, International
Conference on Materials Processing and Characterisation, IC MPC 2014

[3]

SatishChinchanikar, S.K Choudhury, “Evaluation of Chip Tool Interface
Temperature: Effect of Tool Coating and Cutting Parameters during
Turning Hardened AISI 4340 Steel”, International Conference on

Materials Processing and Characterisation, ICMPC 2014

[4]

Atul P. Kulkarni, Girish G. Joshi, Vikas G. Sargade, “Dry Turning of
AISI304 austenitic stainless steel using AlTiCrN coated insert produced
by HPPMS technique”, International Conference on Design and
Manufacturing, IConDm 2013

[5]

Mehul Gosai, Sanket N. Bhavsar,” Experimental Study on Temperature
Measurement in turning Operation of Hardened Steel (EN36)”, 3rd
International Conference on Innovation in Automation and Mechatronics
Engineering, ICIAME 2016

[6]

Rochim, Taufiq. 1993. Teori dan Teknologi Proses Pemesinan. Institut
Teknologi Bandung.

[7]

Kalpakjian, Serope and R.Schmid, Steven. 2009. Manufacturing
Engineering and Technology, sixth edition. New York: Prentice Hall.

[8]

De Garmo, 2008. Materials And Processed in Manufacturing, tenth
edition. John Wiley& Sons, Inc.

[9]

A.I. Fernandez-Abia, et all, “Behviour of PVD coating in the turning of
austenitic stainless steels”,The Manufacturing Rngineering Society
International Conference, MESIC 2013

[10]

Douglas C. Montgomery. 2012. Design and Analysis of Experiments,

Arizona
State
University.
John
Wiley
&
Sons,
Inc.

Universitas Sumatera Utara