Scope of Project Thesis Outline

1.3 Project Objective

The idea is focusing on Automatic Toll Payment System that can operate conveniently and give advantages to the users and toll operator. The objective of this project: i. To develop high performance and low cost Automatic Toll Payment System by using RFID technology. ii. To analyse the effect of output power and distance of the detection with the frequency speed detection in RFID system.

1.4 Scope of Project

In this project, the main part that been covered is developing high performance and low cost Automatic Toll Payment System by using RFID. In order to achieve the objective of the project, there is several scope of work that needs to be considered: i. The project focusing on designing low cost toll payment method with high performance which is high speed detection and secure transaction payment. ii. This system is using passive RFID instead of active RFID that can be functioning without battery which is less expensive. iii. Microsoft Visual Basic Express is used for the framework that is used to structure, plan, and control the information received. iv. Several parameters analysis will be done such as reading range, output power and times per tagging. v. Running the system at frequency of 902.4 MHz – 927.8 MHz

1.5 Thesis Outline

This thesis contains of five chapters. The first chapter concisely discusses the overview about the project such as Project Introduction, Project Objectives, Problem Statement, Scope of Work and Project Methodology. Chapter II describes about the research and information which is the literature review of the project. Every facts and information, which are found through by any references has been selected. This literature review covers the whole things about the toll payment including other countries toll payment system technology. Further research that is related to the toll payment such as Smart Tag and also Touch n go has been done through this literature review. Chapter III will discuss about the methodology that have been used in this project. Methodology is one of the most important things in planning of a project. The project must be understood first and then followed by further research about the previous projects that are related to this project. Chapter IV describes about the result and discussion. In this chapter, the results of the project, all the problems encountered and discussion on the works will be presented. The results that presented here involving the hardware and software part. Finally, Chapter V covers the conclusion and recommendation of the project. The conclusion describes about the task that have been completed for the entire two semesters. On the other hand, the recommendation part is added in order to give an opinion and also for further improvement on future works. CHAPTER 2 LITERATURE REVIEW

2.1 Previous Study and Research