Introduction Data Types Cancel Operation

Co Figure 31 — Data types of the Cancel operation The details of the operation request and response are explained in the following subclauses.

7.3.13.3 Operation Request - Cancel

Sending an instance of the Cancel data type to the service performs an SPS Cancel operation request. The Cancel data type is derived from the SWES ExtensibleRequest data type specified in clause 9 of [OGC 09-001] and therefore inherits all the properties contained in that data type. Cancel does not restrict the content model of ExtensibleRequest. pyright © 2011 Open Geospatial Consortium 123 124 Copyright © 2011 Open Geospatial Consortium Requirement http:www.opengis.netspecSPS2.0reqCancelRequestdataType REQ 100. The Cancel data type shall contain the properties defined for SWES ExtensibleRequest. In addition, it shall contain the property according to Table 61. Table 61 — Property in the Cancel data type Name Definition Data type and values Multiplicity and use task Pointer to the scheduled task to cancel. Task id , see clause 7.3.1.6 value shall be a pointer to a task that is scheduled by the service One mandatory id Note: the primary use of this property is to provide a pointeridentifier – see OGC 09-001 clause 16.3.1 for further details.

7.3.13.4 Operation Response - CancelResponse

The CancelResponse data type represents the response to an SPS Cancel operation request. The CancelResponse data type is derived from the SWES ExtensibleResponse data type specified in clause 9 of [OGC 09-001] and therefore inherits all the properties contained in that data type. CancelResponse does not restrict the content model of ExtensibleResponse . Requirement http:www.opengis.netspecSPS2.0reqCancelResponsedataType REQ 101. The CancelResponse data type shall contain the properties defined for SWES ExtensibleResponse. In addition, it shall contain the property according to Table 62. Table 62 — Properties in the CancelResponse data type Name Definition Data type and values Multiplicity and use result report with the outcome of the cancellation request StatusReport, see 7.3.1.5 Properties of StatusReport shall be used as defined in Table 63 One mandatory