Kinerja Pahat Karbida Berlapis PVD Ketika Memproduksi Shaft Thresser menggunakan Teknologi Pemesinan Keras

56

DAFTAR PUSTAKA

[1]

Varaprasad.Bh, Srinivasa Rao.CH, P.V. Vinay., 2014, “Effect of
Machining Parameters on Tool Wear in Hard Turning of AISI D3 Steel”,
Global Congress on Manufacturing and Management, GCMM 2014

[2]

Suha K. Shihab, et al, “RSM Based Study of Cutting Temperature during
Hard Turning with Multilayer Coated Carbide Insert”, International
Conference on Materials Processing and Characterisation, IC MPC 2014

[3]

SatishChinchanikar, S.K Choudhury, “Evaluation of Chip Tool Interface
Temperature: Effect of Tool Coating and Cutting Parameters during
Turning Hardened AISI 4340 Steel”, International Conference on

Materials Processing and Characterisation, ICMPC 2014

[4]

Atul P. Kulkarni, Girish G. Joshi, Vikas G. Sargade, “Dry Turning of
AISI304 austenitic stainless steel using AlTiCrN coated insert produced
by HPPMS technique”, International Conference on Design and
Manufacturing, IConDm 2013

[5]

Douglas C. Montgomery. 2012. Design and Analysis of Experiments,
Arizona State University. John Wiley & Sons, Inc.

[6]

Kalpakjian, Serope and R.Schmid, Steven. 2009. Manufacturing
Engineering and Technology, sixth edition. New York: Prentice Hall.

[7]

De Garmo, 2008. Materials And Processed in Manufacturing, tenth
edition. John Wiley& Sons, Inc.

[8]

S. S. K.Deepak, “Cutting Speed and Feed Rate Optimization for
Minimizing Production Time of Turning Process”, International Journal of
Modern Engineering Research (IJMER). Vol.2. Issue.5. Sep-Oct. 2012 pp3398-3401

[9]

Christian Aidy Mosey, Rudy Poeng, Johan C. Neyland, “Perhitungan
Waktu dan Biaya Pada Proses Pemesinan Benda Uji Tarik

[10]

Rochim, Taufiq. 2001. Spesifikasi, Metrologi, dan Kontrol Kualitas
Geometrik. Institut Teknologi Bandung.

[11]

Rochim, Taufiq. 1993. Teori dan Teknologi Proses Pemesinan. Institut
Teknologi Bandung.

Universitas Sumatera Utara