Karakterisasi Temperatur Dan Arus Menggunakan Data Akuisisi Labjack U6 Pada DFB Laser Berbasis Labview

KARAKTERISASI TEMPERATUR DAN ARUS MENGGUNAKAN DATA
AKUISISI LABJACK U6 PADA DFB LASER BERBASIS LABVIEW

ABSTRAK

Kestabilan laser dioda jenis DFB (Distributed Feedback) merupakan kunci yang
harus diperhatikan ketika laser tersebut digunakan sebagai sumber cahaya dalam
sebuah sensor maupun instrumen optik. Kestabilan laser DFB ini dapat
dipengaruhi oleh dua faktor yaitu temperatur dan arus injeksi. Perangkat lunak
LabView dengan data akuisisi LabJack U6 digunakan sebagai interface dalam
mengamati parameter kontrol secara spesifik. Dari pengujian didapatkan bahwa
kestabilan temperatur terhadap waktu sebesar 0,0001 ºC/s disebabkan temperatur
dapat mengubah panjang gelombang laser DFB dan kestabilan arus injeksi
terhadap waktu sebesar 0,0005 mA/s disebabkan arus dapat mengubah daya optis
laser. Selain itu didapat pengaruh nilai peningkatan arus injeksi terhadap
temperatur adalah 5,1633 ºC/A dan pengaruh nilai variasi temperatur terhadap
arus injeksi adalah 0,005 mA/ºC. Sehingga penggunaan interface dalam
mengamati parameter kontrol sangat membantu dalam mengamati kestabilan laser
DFB.

Kata kunci : Stabilisasi, Laser DFB, Arus dan Temperatur, Perangkat Lunak

LabView, Data Akuisisi LabJack U6

Universitas Sumatera Utara

CHARACTERIZATION OF TEMPERATURE AND CURRENTS USING
DATA ACQUISITION LABJACK U6 DFB LASER BASED ON LABVIEW

ABSTRACT

Stability DFB laser diode types (Distributed Feedback) is the key that must be
considered when a laser is used as light sources in a sensor and optical
instruments. The DFB laser stability can be affected by two factors: the
temperature and injection current. LabView software with data acquisition
Labjack U6 is used as an interface to control specific parameters observed. The
testing it was found that the stability of temperature versus time of 0,0001 ºC/s
due to the temperature can change the wavelength of the DFB laser and injection
current stability with respect to time of 0,0005 mA/s due to the current can change
the optical power of the laser. In addition it obtained the influence of injection
current value of the temperature increase is 5,1633 ºC/A and the influence of
temperature variations on the current value of the injection 0,005 mA/ºC. So the

use of the interface in observing the control parameter is helpful in observing
stability DFB laser.

Keywords : Stability, DFB Laser, Current And Temperature, LabView Software,
Data Acquisition LabJack U6

Universitas Sumatera Utara