Perancangan Alat Ukur Kelembaban Tanah Menggunakan Metode Konfigurasi Wenner Berbasis Mikrokontroler Atmega 16

PERANCANGAN ALAT UKUR KELEMBABAN TANAH
MENGGUNAKAN METODE KONFIGURASI WENNER BERBASIS
MIKROKONTROLER ATMEGA 16

Abstrak

Pendeteksi kadar kelembaban tanah telah berhasil dilakukan menggunakan sensor
elektroda empat titik berdasarkan meetode konfigurasi Wenner. Pengukuran
dilakukan dengan mencampurkan tanah kompos dan air dan kemudian, diinjeksi
arus listrik kedalam tanah antara dua elektroda terluar. Sebagai hasil dari injeksi,
dihasilkan beda potensial antara dua elektroda yang lainnya yang berada di
tengah. Perbedaan dalam nilai tegangan dipengaruhi oleh volume air. Dalam
penelitian ini, variasi volume air berturut-turut adalah 100, 200, 300, 400 dan 500
mL dalam 1000 gr tanah kompos. Hasilnya menunjukkan bahwa tegangan output
sensor adalah 957.94, 553.10, 423.99, 329.71, 272.93 mV untuk volume air
masing-masing 100, 200, 300, 400 dan 500 mL. Dari data diperoleh nilai
konduktivitas adalah 0.048, 0.083, 0.109, 0.14, 0.169 untuk volume air masingmasing 100, 200, 300, 400 dan 500 mL. Berarti bahwa kenaikan konduktivitas
dipengaruhi oleh kenaikan volume air. Hasil yang lain menggunakan metode
Gravimetri menunjukkan bahwa persentase kadar kelembaban tanah adalah 13,
20, 32, 38, 47 % untuk volume air masing-masing 100, 200, 300, 400 dan 500
mL. Ini berarti bahwa kenaikan persentase kadar kelembaban tanah adalah

sebanding dengan kenaikan volume air. Hal ini dapat disimpulkan bahwa
kenaikan nilai konduktivitas mengindikasikan kenaikan dalam persentase kadar
kelembaban tanah. Oleh karena itu, metode konfigurasi Wenner dapat digunakan
untuk mendeteksi kadar kelembaban tanah dengan bebrapa keunggulan seperti
mudah, cepat, praktis dan ekonomis.

Kata kunci : Kadar kelembaban tanah, konfigurasi Wenner, gravimetri,
mikrokontroler

iv

DESIGN OF SOIL MOISTURE TESTER USING WENNER
CONFIGURATION METHOD BASED ON ATMEGA 16
MICROCONTROLLER

Abstract

The detection of soil moisture content has been successfully done using a four
point probe sensor based on Wenner configuration methode. The testing was
carried out by mixing water and composts oil and then, electric current was

injacted into the soil between two outer electrodes. As a result of the injection, the
potensial diffrence was generated between two another electrodes positioned in
the center. The diffrence in voltage values was affected by the water volume. In
this work, the variation of water volume was 100, 200, 300, 400 and 500 mL in
1000gr compost soil, respectively. The result showed that the output voltages of
sensor were 957.94, 553.10, 423.99, 329.71, 272.93 mV for the water volumes of
100, 200, 300, 400 and 500 mL, consecutively. And from the output voltages of
sensor showed that conductivity values were 0.048, 0.083, 0.109, 0.14, 0.169 for
the water volumes of 100, 200, 300, 400 and 500 mL, consecutively. It means
that the increase in conductivity correspondend with the increase in the water
volumes. The other result of using Gravimetric method evidenced that the
percentages of soil moisture content were 13, 20, 32, 38, 47 % for the water
volumes of 100, 200, 300, 400 and 500 mL, consecutively. This means also that
the increase in the water volumes. This can be concluded that the increase in
conductivity value indicated the increase in soil moisture content percentages.
Therefore, Wenner configuration methode can be used to detect the soil moisture
content with some advantages including easy, fast, practice and economy.

Keywords : Soil moisture content, Wenner configuration, gravimetric
microcontroller.


v