Enabling and Disabling Synchronization Profiles

Managing Directory Synchronization Profiles 7-11 Test Params This section describes the Test Params screen, which is the second screen of the three screen DIP Tester wizard. If running DIP Tester in Advanced mode, select and configure the source of the test data. To test sync a specific change, either enter a change number or enter the SourceDN. Otherwise, enter synchronization instructions using LDIF Lightweight Directory Interchange Format statements. If running DIP Tester in Basic mode, the options are preconfigured. Click Next in the top right corner of the screen to go to step three of the wizard, Review Options and Test Output. View Test Data Optional. This lookup feature is provided so that you can view change log data, source directory data, and destination directory data without leaving DIP Tester. Select one of the following options form the drop-down menu to view the test data inside of DIP Tester. ■ View Change Log Entry - For directories that support change logs specify the change log and enter a number in the Change Number box. The change number is retrieved from the source. Port Configured port number for the synchronization job connection. SSL Settings Indicates that SSL is disabled if the check box is empty. User Name User account that the profile uses to authenticate to the source directory. Table 7–3 Synchronization Profile Properties, Advanced Property Description Last Change Number Identifies the most recent change number in the change log that synchronization has been performed for. Skip Error To Sync Next Change If true, specifies that the profile should continue the synchronization job if an error occurs. If false, the sync job is aborted. To change this value, edit the synchronization profile, select the Advanced tab, and edit the parameter in the Additional Configuration Parameters section. Update Search Count Specifies the maximum number of iterations to be performed on the connected directory during the synchronization process. The synchronization process stops after the specified number of searches has been performed. To change this value, edit the synchronization profile, select the Advanced tab, and edit the parameter in the Additional Configuration Parameters section. Note: Failed change numbers cannot be determined automatically. Instead, refer to audit logs for failed change numbers. Table 7–2 Cont. Synchronization Profile Properties, Source Details or Destination Property Description