Document Deficiencies. If any document has deficiencies, return it to the

July 2013 44 3 Calibration Standards. a The calibration standards of all test and measuring equipment, except those used in continuity checks for troubleshooting, will receive testing at regular intervals to a standard derived from the Komite Akreditasi Nasional or National Accreditation Committee KANNAC or a standard provided by the manufacturer. NOTE: i. The part 145 rule states that tooling is calibrated to a national standard or other standard acceptable to the DAAO. ii. An AMO must have an exemption authorization if it uses equipment of a manufacturer and does not address the method of calibration. Currently, exemptions of this type last for 2 years and are renewable if requested by the AMO. b. Test and inspection equipment and special tooling equivalent manufactured by an AMO must meet the calibration standards recommended by the manufacturer of the article being measured or tested. This type of test equipment calibration will be traceable to a KANNAC standard or a standard acceptable to the DAAO. 4 Facilities are adequate to perform the functions as defined in the AMO manual and QCM.

c. Evaluate Maintenance Organization. Ensure the following:

1 The inspection system is in place see chapter V of this SI to ensure: a Employees are familiar with and are capable of performing their assigned duties, b The system for reporting serious defects or unairworthy conditions is in place to ensure compliance with CASR Part 145.221, c The maintenance recordkeeping system is in place to ensure compliance with part 43 and CASR Part 145.219, and d The AMO has a QC system in place that ensures the articles upon which the AMO or any of its contractors perform a maintenance function are Airworthy. 2 There are a sufficient number of personnel to satisfy the volume and type of work to perform, as required by part 145 subpart D: a Ensure the AMO designates an employee as the accountable manager;