GPSMAP 60CSx Owner’s Manual
Heading Setup Page
speed setting
Time delay options
5. Use the numeric keypad to enter a speed. 6. Highlight the for more than ield, and press
EntEr
to set the time delay from the time options list.
calibrating the Electronic compass Calibrate the electronic compass outdoors when you
first use the GPSMAP 60CSx. To ensure continued accuracy, calibrate after installing new batteries,
after moving more than 100 miles 160 km, or experiencing a temperature change greater than 68º F
20º C. The accuracy of the compass is also affected if the unit is not held level or you are near objects that
affect magnetic fields, such as cars or buildings.
1. Press MEnu to open the Compass Page
Options menu.
2. Highlight calibrate compass, and press EntEr
to open the Calibration Page.
3. With the Start button highlighted, press EntEr
, and follow on-screen directions for holding and turning the unit.
A “Just Right,” “Too Fast,” or “Too Slow” message appears notifying you to adjust your
turning speed, as needed. Hold the unit level while turning.
A “Calibration Successful” message appears when inished.
If a “Calibration Failed” message appears, repeat the process.
4. Press EntEr to return to the Compass Page.
Hold the unit level and turn
slowly.
GPSMAP 60CSx Owner’s Manual
Use the options menu to customize the Compass Page. With the Compass Page open, press MENU. To
select an option, highlight it and press ENTER.
compass Page options
The following options are available:
• Sight ‘N Go—allows you to navigate to an
object within your sight by pointing the unit at it.
• Stop or Resume Navigation—turns active
navigation for a route or a Go To on or off.
• Recalculate— recalculates the path to a
destination.
• Course or Bearing Pointer—toggles between
the course pointer and the bearing pointer.
4 data ields that appear on the Compass Page.
• Change Data Fields—allows you to select the
type of data you want to show in the data ields. See
page 93 for deinitions of each option.
• Calibrate Compass—accesses the Compass
Calibration Page.
• Restore Defaults—returns to the factory
settings.
Sight ‘N Go Navigation
Sight ‘N Go allows you to set a course to a point you can see in the distance.
to use Sight ‘n Go to navigate:
1. Press MEnu to open the Compass Page
Options Menu.
2. Highlight Sight ‘n Go, and press EntEr to
start the Sight ‘N Go feature. The compass ring with pointer is in-line with the two sighting
marks on the case the top arrow of the rocKEr
and tic mark at the top of display bezel.
GPSMAP 60CSx Owner’s Manual
two sighting marks with the distant object.
With Press EntEr to lock the direction. The
Sighting Page opens.
Sighting Page
4. Highlight Set course, and press EntEr to
open the Compass Page. Begin traveling to your destination on a course
line using the course pointer as a guide. or
Highlight Project Waypoint, and press EntEr
to open the Project Waypoint Page. 5. Enter an estimated distance from your current
location to establish a projected waypoint location.
Project Waypoint Page
6. Highlight the Go to button, and press EntEr