Data Collection Procedure Comparison Of Taxis And Logical Semantic Systems In Indonesian And Malaysian Newspapers About Airasia Qz8501 Accident

32 The articles are determined based on preliminary observation. Both articles are about similar topic. The number of sentences in each article is 30 sentences. 2. Collecting the Data The first article is an online article taken from newspaper website www.nst.com.my, an official website of New Straits Times. On the other hand, the second article is collected from printed The Jakarta Post which is published daily. The data collected are clause complexes from valid sentences contained in both articles. 3. Classifying the Data Both articles are then re-observed. Each sentence of the text is then classified either it is a clause or a clause complex of two, three or more clauses. Both clauses and clause complexes are presented.

3.4. Data Analysis

In analyzing the data, the techniques used are based on procedures for a Systemic Functional Linguistic analysis, an investigation into clause complexing relations. The data analysis includes: a Displaying all the clause complexes in a table, b Numbering each clause complex, c Identifying taxis relation d Identifying logical semantic relation and each marker, e Counting all the identified elements using a simple percentage formula. The formula is: F P = x 100 N 33 P = Percentage of logical semantic relation or taxis type F = The number of particular type found in clause complexes N = The number of clause complexes data After the type of logical semantic relation and its interdependence are identified, the dominant type of logical semantic relation and interdependence is obtained. It is to know why that type of particular logical semantic relation appears rather than other types. Furthermore, it is interpreted to see the characteristics of the newspaper text based on logical semantic relation and its interdependence.

3.5. Research Procedure

This research goes through a procedure. They are: 1. Preparation This preparation includes the theory, the data, research procedure and data analysis. 2. Collecting the data The data are collected from the data source by following the data collection procedure. It includes classifying between clauses and clause complexes. After that, all the data are displayed onto the workplace. 3. Analyzing the Data The data is analyzed by classifying the logical semantic relation type and its interdependence type. Procedure of analyzing is as follows: a Each article is labeled A and B.