Pembuatan Nanosilikon Dari Pasir Alam Secara Magnesiotermik Dengan Penambahan Kalium Klorida
iv
PEMBUATAN NANOSILIKON DARI PASIR ALAM SECARA
MAGNESIOTERMIK DENGAN PENAMBAHAN
KALIUM KLORIDA
ABSTRAK
Telah dilakukan penelitian tentang pembuatan Nanosilikon dari pasir alam secara
Magnesiotermik dengan penambahan kalium klorida dengan cara ultrasonik. Pasir
mula-mula diekstraksi dengan HCl dan H2SO4 dan dianalisa dengan analisa XRD.
Selanjutnya silika direduksi menjadi silikon secara magnesiotermik dengan
perbandingan SiO2 : Mg adalah 1 : 2, pada suhu 800 0C selama 6 jam. Kemudian
hasil reduksi dimurnikan dengan dua metode. Metode pertama yaitu dengan
menggunakan akuabides, HCl 2 N, campuran HCl 2N dan CH3COOH 25 %, serta
campuran CH3COOH 25% dengan HF 4,8% dengan pemanasan pada suhu 80 0C
selama 3 jam. Dan metode kedua yaitu dengan meningkatkan konsentrasi HCl 5N,
dan HF 10% tanpa pemanasan. Hasil pemurnian dari kedua metode dianalisa
dengan menggunakan analisa XRD dan diperoleh hasil pemurnian dari metode
pertama 40,4% dengan ukuran partikel 42,993 nm – 58,567 nm dan dari metode
kedua 64,7% dengan ukuran partikel 40,372 nm – 62,779 nm.
Kata Kunci : Pasir Alam, Nanosilikon, Ultrasonik, Magnesiotermik, Silika
Universitas Sumatera Utara
v
THE SYNTHESIS OF NANOSILICON FROM NATURAL SAND BY
MAGNESIOTHERMIC METHOD WITH
POTASSIUM CHLORIDE
ABSTRACT
The research of synthesis nanosilicon from natural sand by magnesiothermic
method with the additional of potassium chloride with ultrasonic. The Sand is
initially extracted with HCl and H2SO4 and analyzed XRD. Then silica reduced
to silicon by magnesiotermic method with ratio SiO2 : Mg was 1:2, at temperature
of 800°C for 6 hours. Then the result of reduction is purified by two methods. The
first method is to usemakuabides, HCl 2N, mixture of HCl 2N and CH3COOH
25% and mixtures CH3COOH 25% with HF 4,8% with heating at 80°C for 3
hours. And the second method is to icrease the concentration of HCl 5N, and HF
10% without heating. The purification results of the two methods were analyzed
using an analysis XRD and obtained purification results from the first method
40,4% with particle size of 42,993 nm – 58,567 nm and from second method
64,7% with particle size of 42,993 nm – 58,567 nm.
Keywords : Natural sand, Nanosilicon, Magnesiothermic, Ultrasonic, Silica
Universitas Sumatera Utara
PEMBUATAN NANOSILIKON DARI PASIR ALAM SECARA
MAGNESIOTERMIK DENGAN PENAMBAHAN
KALIUM KLORIDA
ABSTRAK
Telah dilakukan penelitian tentang pembuatan Nanosilikon dari pasir alam secara
Magnesiotermik dengan penambahan kalium klorida dengan cara ultrasonik. Pasir
mula-mula diekstraksi dengan HCl dan H2SO4 dan dianalisa dengan analisa XRD.
Selanjutnya silika direduksi menjadi silikon secara magnesiotermik dengan
perbandingan SiO2 : Mg adalah 1 : 2, pada suhu 800 0C selama 6 jam. Kemudian
hasil reduksi dimurnikan dengan dua metode. Metode pertama yaitu dengan
menggunakan akuabides, HCl 2 N, campuran HCl 2N dan CH3COOH 25 %, serta
campuran CH3COOH 25% dengan HF 4,8% dengan pemanasan pada suhu 80 0C
selama 3 jam. Dan metode kedua yaitu dengan meningkatkan konsentrasi HCl 5N,
dan HF 10% tanpa pemanasan. Hasil pemurnian dari kedua metode dianalisa
dengan menggunakan analisa XRD dan diperoleh hasil pemurnian dari metode
pertama 40,4% dengan ukuran partikel 42,993 nm – 58,567 nm dan dari metode
kedua 64,7% dengan ukuran partikel 40,372 nm – 62,779 nm.
Kata Kunci : Pasir Alam, Nanosilikon, Ultrasonik, Magnesiotermik, Silika
Universitas Sumatera Utara
v
THE SYNTHESIS OF NANOSILICON FROM NATURAL SAND BY
MAGNESIOTHERMIC METHOD WITH
POTASSIUM CHLORIDE
ABSTRACT
The research of synthesis nanosilicon from natural sand by magnesiothermic
method with the additional of potassium chloride with ultrasonic. The Sand is
initially extracted with HCl and H2SO4 and analyzed XRD. Then silica reduced
to silicon by magnesiotermic method with ratio SiO2 : Mg was 1:2, at temperature
of 800°C for 6 hours. Then the result of reduction is purified by two methods. The
first method is to usemakuabides, HCl 2N, mixture of HCl 2N and CH3COOH
25% and mixtures CH3COOH 25% with HF 4,8% with heating at 80°C for 3
hours. And the second method is to icrease the concentration of HCl 5N, and HF
10% without heating. The purification results of the two methods were analyzed
using an analysis XRD and obtained purification results from the first method
40,4% with particle size of 42,993 nm – 58,567 nm and from second method
64,7% with particle size of 42,993 nm – 58,567 nm.
Keywords : Natural sand, Nanosilicon, Magnesiothermic, Ultrasonic, Silica
Universitas Sumatera Utara