Seleksi Galur Kedelai (Glycine max (L.) Merill ) Generasi F3 Pada Tanah Salin Dengan Metode Pedigree

i

ABSTRACT
BILLY CHRISTIAN : Selection of Soybean’s(Glycine max (L.) Merill )line F3
Generation on the Saline land by Pedigree Methode, Supervised by REVANDY
I.M DAMANIK and ROSMAYATI.
The research aimed to choose Soybean (Glycine max (L.) Merill ) that can
be grown and produced well on the Saline land at F3 generation . The research
has done at the experiment land of Agriculture Faculty, University of Sumatera
Utara , Medan on ±25 Meters altitude above sea level, which done in August
2015 till January 2016.By using path analysis of soybean Anjasmoro variety. The
parameters which observed were number of productive branches, day to
flowering, day to harvest, number of pods, number of empty pods, Seeds
production per plant, weight of seed per plant.
The result of research shown that plant had highest production was
P1(61) 7,2 g, the lowest was P3(84) 0,1 g and had gotten limit selection was 2,67,2 g.
Component that had give highest direct effect to seeds production per
plant was number of seeds per plant that was 0,96. And component that had give
highest indirect impact was mumber of pods that was 0,84.
Key word : Saline, Selection, Soybean, Varieties


i

Universitas Sumatera Utara

ABSTRAK
BILLY CHRISTIAN : Seleksi Galur Kedelai (Glycine max (L.) Merill ) Generasi
F3 Pada Tanah Salin Dengan Metode Pedigree, dibimbing oleh REVANDY I.M
DAMANIK dan ROSMAYATI.
Penelitian ini bertujuan untuk memilih tanaman kedelai ( Glycine max (L.)
Merill ) yang dapat tumbuh dan berproduksi secara baik pada generasi F3 di tanah
salin. Penelitian dilakukan di Lahan Percobaan Fakultas Pertanian, Universitas
Sumatera Utara, Medan dengan ketinggian tempat ± 25 m dpl, yang dilaksanakan
pada bulan Agustus 2015 hingga Januari 2016. Menggunakan analisis sidik lintas
pada kedelai varietas Anjasmoro. Parameter yang diamati adalah jumlah Cabang
produktif, umur berbunga, umur panen, jumlah polong, jumlah polong hampa,
produksi biji per tanaman, dan berat biji pertanaman .
Hasil penelitian menunjukkan bahwa tanaman yang memiliki produksi
tertinggi yaitu pada nomor tanaman P1(61)7,2 g, yang terendah pada nomor
tanaman P3(84) 0,1 g dan diperoleh batas seleksi 2,6-7,2 g .
Komponen yang memberikan pengaruh langsung tertinggi terhadap

produksi biji per tanaman adalah adalah jumlah biji pertanaman yaitu sebesar 0,96
dan komponen yang memberikan pengaruh tidak langsung yang terbesar adalah
langsung jumlah polong sebesar 0,84.
Kata kunci : Kedelai, Salin, Seleksi, Varietas

ii
Universitas Sumatera Utara