Facilities General Aircraft and Avionics

Page 92 Part 2 ✈ Chapter 3 - Checklists MRA – 1st Edition September 1998 Part 2 ✈ Chapter 2 - Airworthiness Audit Policy and Procedures CAR 423.083diD References Result This applies to both general aircraft and avionics courses. A-7 Does the facility have a woodworking section? Is the area sufficiently large to contain the equipment required to make and repair wood and fabric? TCM OK FDG NA A-8 Does the facility have a paint section? Is the area sufficiently large to contain the equipment required to carry out doping and spray painting? TCM OK FDG NA A-9 Does the facility have a cleaningdegreasing area? Is this a separate space equipped with a washtank and degreasing equipment? TCM OK FDG NA A-10 Does the facility have an engine run-up area? Is it separate from the work area? Is it in the form of a test cell or tie-down area? Is the safety of the students assured? TCM OK FDG NA A-11 Does the facility have two segregated battery sections? Are they separated from other work areas? Do these areas have proper ventilation, sealed electrical systems and safety systems? Are they equipped to inspect, maintain and charge both nickel-cadmium nicad and lead acid batteries? TCM OK FDG NA This applies to both general aircraft and avionics courses. Part 2 ✈ Chapter 3 - Checklists Page 93 Part 2 - Airworthiness Audit Policy and Procedures MRA – 1 st Edition September 1998 CAR 423.083diD References Result A-12 Does the aircraft maintenance facility have the following equipment and component sections: - avionics; - electrical; - powerplants reciprocating and turbine; - fuels; - pneumatic and vacuum; - instruments: magnetic, gyro and pitot-static; - hydraulics; - powertrains helicopter; and - propellers? Are these sections provided with adequate equipment and special tools to disassemble, repair, service, inspect, test and reassemble these components? TCM OK FDG NA A-13 Does the facility for avionics maintenance facility have the following equipment and component sections: - avionics; - electrical; - powerplants; - pneumatics; - instruments: magnetic, gyro and pitot-static; - hydraulics; - flight controls; and - auto-pilots? TCM OK FDG NA This applies to both general aircraft and avionics courses. Items Certified - Completed by: Page 94 Part 2 ✈ Chapter 3 - Checklists MRA – 1st Edition September 1998 Part 2 ✈ Chapter 2 - Airworthiness Audit Policy and Procedures

3.7.2.4 Reference Material

CAR 423.083diE References Result A-1 Does the basic training organisation have procedures in place to ensure that the following are available and kept up to date with amendments: - the aviation regulations; - the airworthiness standards; - the licensing standards; - the appropriate ADs; - type certificates and supplementary type certificates for primary training aircraft; - a complete set of manuals for primary training aircraft; and - one copy of each textbook required for the course of study? TCM OK FDG NA A-2 Does the organisation have policies and procedures in place for manuals that will not be maintained in an amended status? TCM OK FDG NA A-3 Are these manuals identified so as to ensure that the reader is aware of their status? TCM OK FDG NA Items Certified – Completed by:

3.7.2.5 Class Size

CAR 423.083diF References Result A-1 Does the basic training organisation have policies and procedures regarding class size? TCM OK FDG NA Part 2 ✈ Chapter 3 - Checklists Page 95 Part 2 - Airworthiness Audit Policy and Procedures MRA – 1 st Edition September 1998 CAR 423.083diF References Result A-2 Do classes contain more than 25 students? If so, is the organisation able to justify the class size by ensuring that there are sufficient instructors, space and equipment? TCM OK FDG NA A-3 Does the organisation have sufficient instructors or qualified supervisors to ensure both the quality of work and the safety of the students during practical tasks? TCM OK FDG NA A-4 Is the supervisor-student ratio appropriate for the task being accomplished? The guideline of a 1:6 ratio may be used as an average. TCM OK FDG NA Items Certified – Completed by:

3.7.2.6 Advisory Committee

CAR 423.083ai References Result A-1 Does the training organisation have a TCM? TCM OK FDG NA A-2 Is there a diverse industry representation on the committee? TCM OK FDG NA A-3 Does the TCM describe the committees duties and responsibilities? TCM OK FDG NA A-4 Does the advisory committees mandate ensure that the course curriculum is current from an industry standpoint? TCM OK FDG NA